Encoder - Electronical Speed Sensor

Our contactless electronical speed sensor is suitable for advanced control tasks in rough applications.
The encoder is based on a two-pole axial magnetized permanent magnet, combined with Hall sensors which are integrated in a micro-chip on the electronic board.

The electronic is suitable for high temperatures and for a wide range of supply voltages. It is assembled in a housing which is protecting against moisture and which is EMC shielded.
The encoder is linked to the motor shaft by an elastomer coupling.

Meanwhile an add-on module is available on the market which gives the opportunity to use the encoder on motors together with a standard controller.

• Supply voltage from 16 VDC to 36 VDC
• Output voltage of signal from 16 VDC to 36 VDC
• Current consumption < 65 mA
• Resolution 32 pulses/rpm (programmable up to 512 pulses)
• Quadrature accuracy 90° +/- 5%
• Rise time < 1 µs
• Maximum speed 38.000 rpm
• Range of operating temperature from –20° C to +100° C
• Degree of protection (assembled to the motor) IP65
• Shock and vibration proof